Variocage Assembly and Adjustment Guide

Variocage Assembly Guides

Variocage Double Assembly Video

Variocage Single Assembly Video

Video Demonstration on Adjusting the Depth of your Variocage

Adjusting the Top of your MIM Variocage

Step One: Measure the distance between the top panel seam and top panel leading edge (Diagram #1 – Measurement (A)) .

Step Two: Measure the distance between the opposite top panel seam and top panel leading edge (Diagram #1 – Measurement (B)).

Step Three: If Measurement (A) equals Measurement (B), no further adjustment is needed. If Measurement (B) does not equal Measurement (A), adjust Measurement (B) until it equals Measurement (A). To do so, loosen the black knobs on top of cage and adjust until Measurement (A) matches Measurement (B). Once Measurement (A) and Measurement (B) are equal, re-tighten black knobs.

Please Note: If your cage rattles, you will need to compress the top of the cage. To do so, loosen the black knobs on the top of the cage, compress the top of the cage 1/8” to 1/4”, and retighten knobs. Make sure you follow the three steps above after you make this adjustment to ensure Measurement (A) and Measurement (B) are equal.

VARIOCAGE DOG KENNEL VIDEO INSTRUCTIONS DIAGRAM 1

Adjusting the Bottom of your MIM Variocage

Step Four: Measure the distance between the floor panel seam and the outside leading edge on the left side of the cage (Diagram #2).

Step Five: Measure the distance between the floor panel seam and the outside leading edge on the right side of the cage.

Step Six: If this measurement on the left and right side of the cage are equal, no further adjustment is necessary. If this measurement is NOT the same on the left and right side of the cage, adjust until this measurement is equal on both sides. To do so, loosen the black knobs on both sides of the cage and adjust until both sides are equal. Once both sides are equal, re-tighten black knobs.

VARIOCAGE DOG KENNEL VIDEO INSTRUCTIONS DIAGRAM 2

Recover password